49
Metering
If you cannot obtain suitable exposure conditions, you can change the metering method to
take brighter pictures.
[Multi] ( ) : Exposure will be calculated based on an
average of the available light in the
image area. However, the calculation
will be biased towards the centre of the
image area. This is suitable for general
use.
[Spot] ( ) : Only the rectangular area in the centre
of the LCD monitor will be metered for
light. This is suitable when the subject in the centre is exposed correctly,
regardless of the back lighting.
The default metering mode is Multi pattern metering.
If the subject is not the centre of the focus area, do not use the spot metering as this may
result in an exposure error. In this circumstance, It is better to use exposure
compensation.
INFORMATION
Continuous shot
Select the number of pictures in continuous shooting.
- [Single] : Take one picture only
- [Continuous] : Images will be taken continuously until
the shutter button is released. The
shooting capacity depends on the
memory.
[MANUAL mode]
1
* High resolution and picture quality increases file saving
time, which increases stand-by time.
* If the [Continuous] sub menu is selected, the flash will be off automatically.
Metering
Multi
Spot
2592
Shooting
Single
Continous
NOR
To Next Page
Loading...
