51
Metering
When the camera cannot calculate a proper exposure, you can change the metering method.
1. Rotate the mode dial to the RECORDING mode and press the MENU button.
2. Press the DOWN and the cursor will be shifted to the main menu.
3. Select [METERING] menu by pressing the UP/DOWN button.
Press the OK button to confirm the setting.
Press the menu button twice and the menu display will be disappeared. Take a picture.
4. Press the RIGHT button and the cursor will shift to the
[METERING] sub menu. Select the desired sub menu by
pressing the UP/DOWN button.
- Multi pattern metering : Exposure will be calculated based on
an average of the light available in
the image area. However, the
calculation will be biased towards the
centre of the image area.
- Spot metering : Use this function when there is
backlight or when photographing a
subject that has little contrast. In
backlighting conditions adjust the
light metering to suit the subject
matter.
INFORMATION
The default metering mode is Multi pattern metering.
If the subject is not on the centre of the focus, do not use the spot metering as there may be
exposure error. In this case, use the exposure compensation.
Even though the camera is restarted, the metering setting is maintained.
EXIT: MENU
PORTRAIT SETUP MyCAM
PAGE :
SIZE
QUALITY
METERING
SHOOTING
L 2272X1753
FINE
MULTI
SINGLE
To Next Page
Loading...
Need help?
General
