3-1
3. Disassembly and Reassembly
3. Disassembly and Reassembly
3-1. Tools for Removal and Reassembly
Tool image
No. Tool Type Remarks
➊
Adjustable Wrench
➋
Open-end Wrench 1-7/16” Leg
➌
Vice pliers
➍
Others
(screwdriver, nipper, long nose pliers)
Common tools for servicing
Screwdriver - Philips, at, Torx T20
* Preparation for parts replacement
1. Take out the residual water inside the product.
(Drain the water by operating the drain pump)
2. Close the water supply valve.
3. Turn off the power & disconnect power cable.
You must turn off the circuit breaker connected to the product.
4. Pull out the unit from the sink and lay it on the oor.
Be careful of the drain hose when pulling out the unit.
To Next Page
Loading...
Need help?
General
