While Servicing
Check if the power cable is damaged, attened, cut or otherwise degraded. ࣃ
If faulty, replace it immediately. ➢
Failing to do so may result in electric shock or re.
Completely remove any dust or foreign material from the housing, wiring and connection
ࣃ
parts.
This will prevent a risk of re due to tracking and shorts in advance. ➢
When connecting wires, make sure to connect them using the relevant connectors and
ࣃ
check that they are completely connected.
If tape is used instead of the connectors, it may cause re due to tracking. ➢
Make sure to discharge the PBA power terminals before starting the service.
ࣃ
Failing to do so may result in a high voltage electric shock. ➢
When replacing the heater, make sure to fasten the holder heater after ensuring that it is
ࣃ
inserted into the bracket-heater.
If not inserted into the bracket-heater, it touches the tub and causes noise and ➢
electric leakage.
After Servicing
Check for any water leakage. ࣃ
Perform a test run for the dishwasher using the standard(normal) cycle and check ➢
whether there is any water leakage through the oor section or the pipes.
Do not allow consumers to repair or service any part of the dishwasher themselves.
ࣃ
This may result in personal injury and shorten the product lifetime. ➢
If it seems that grounding is needed due to water or moisture, make sure to run ࣃ
grounding wires.
(Check the grounding of the power outlet, and additionally ground it to a metallic water
pipe.)
Failing to do so may result in electric shock due to electric leakage. ➢
[Running a grounding wire]
- Twist a grounding wire (copper wire) two or three times around the tap.
- If you connect the grounding wire to a copperplate, bury it 75 cm under the earth in a
place with a lot of moisture.
Do not connect the grounding wire to a gas pipe, plastic water pipe or telephone
wire. There is a risk of electric shock or explosion.