EasyManua.ls Logo

Samsung DV448AEP - No Problem

Samsung DV448AEP
130 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
30 _ Troubleshooting
No Problem What to do
4
Blowsfusesortripscircuit
breaker
- Isthebeltconnectedwell?
- Isthewindingofthemotorcontinuous?(Rotorwinding,statorwinding,generator)
- Isthemotorprotectornormal?
• Ifabovepointsarenotfound,thePCBassemblyisoutoforder.Replaceit.
5
Blowsfusesortripscircuit
breaker(GasModel)
• Duringignitionthedryerwilldraw6amps.WiththeburnerON,thedryerwilldraw4.5amps.
Ifthedryerisdrawingamperagesabovethis,thenthehousewiring,fuseboxorcircuit
breakerissuspectedtobeatfault.
• Igniterharnesslooseandshortedtobase.
• Incorrectwiringorwireshortedtoground.
• Drivemotorwindingshortingtoground.
6 Willnotheat(motorruns)
Openheatingelement.
• Hi-Limittripseasilyorisopen.
• Regulatingthermostattripseasilyorisopen.
• Membraneswitchopen.
• CheckThermistor.
7
WillNotDryGasModelPoor
Gas Ignition
Whenthedryerisoperatedonaheatsetting,theignitershouldbeenergizedandburnershall
rewithin45secondsat120VAC.Thefailureofacomponentinthissystemwillusuallybe
indicatedbyoneofthreesymptoms(No.8,No.9,No.10)
8 Theigniterdoesnotglow
Iftheigniterdoesnotheatup,removepowerandusinganohmmeter,checkthefollowing:
• Openamesensor
• Openigniter
• Shortedboostercoil
• Openwiring
• Badmotorswitch(Neutralsupply)
• Nopowerfromcontrol(L1supply)
9 Igniterglows-Nogasignition
Iftheigniterheatsupbutthemainburnerameisnotignited,removepowerandusingan
ohmmeter,checkthefollowing:
• Opensecondarycoil
• Openholdingcoil
• Openwireharness
• Stuckamesensor(Stuckclosed)
10
Thegasisignitedbutthe
amegoesout
Ifanormalignitiontakesplaceandafterashortwhiletheamegoesout,checkforthe
following:
• Radiantsensorcontactsopeningprematurely.
• WeakgasvalvecoilmayopenwhenstressedbyhigherTemps.
• WeakHi-Limit
• Poorventing
• Baddrumseals
11
Improperdryingclothes
wrinkledRoughtexturelong
dry time
• Thelintlterisnotclean.
• Anyrestrictionintheexhaust.
• Theoutsideexhausthooddamperdoorstuckclosed.
• Istheexhausttoolong,toomanyelbows,exductworkinstalled.
• Poorintakeairavailableforthedryer.
• Incorrecttumblerspeed.Tumblerbeltslipping.
• Blowerimpellerbound;checkforforeignmaterialinblowerarea.
• Customeroverloadingdryer.
• Checkclothinglabelsforfabriccontentandcycleselected.
• Clothestoowetduetoinsufcientspinoutbywasher.
12 Noisyand/OrVibration
• “Thumping”Checkforloosetumblerbafe,reartumblerroller(s)wornormisaligned,out-of-
roundtumblerorhighweldseamontumbler.
• “Ticking”Checkforloosewireharnessorobjectcaughtinblowerwheelarea.
• ScrapingCheckforfrontorrearbulkheadfeltsealoutofpositionorworntumblerfront
bearings.
• “Roaring”Checkforblowerwheelrubbingonblowerhousingorbadmotorbearings.
• Poppingorsquealingsound.Checkforastickyorfrayedbelt.

Table of Contents

Related product manuals