How to fix Samsung DVD-F1080W remote control not working?
If the remote control isn't working with your Samsung DVD Player, first, try replacing the batteries. If that doesn't work, make sure you're within 20 feet of the player. As a last resort, remove the batteries, press and hold any button(s) for a few minutes to reset the remote's microprocessor, then reinstall the batteries.
Why is my Samsung DVD-F1080W not playing 5.1 channel sound?
If your Samsung DVD Player isn't producing 5.1 channel sound, ensure that the DVD player is properly connected to the correct amplifier, and that the disc itself is recorded with 5.1 channel sound. Also, check the disc for a '5.1 ch' mark and verify that your audio system is correctly connected and functioning. Finally, confirm that the Audio Output in the SETUP Menu is set to Bitstream.
What to do if my Samsung DVD-F1080W DVD Player disc does not play?
If your Samsung DVD player isn't playing a disc, make sure the disc is placed with the label side facing up. Also, verify that the region number of the DVD is compatible with your player.
Why is there no audio from my Samsung DVD Player?
If you're not getting any audio from your Samsung DVD Player, ensure that you've selected the correct Digital Output in the Audio Options Menu.
Why is there no HDMI output from my Samsung DVD-F1080 DVD Player?
If there's no HDMI output from your Samsung DVD-F1080, check that the Video output is HDMI enabled. Also, verify the connection between your TV and the HDMI jack on the DVD player. Finally, ensure your TV supports the DVD player's resolution (480p/576p/720p/1080i/1080p).
Why is the picture noisy or distorted on my Samsung DVD Player?
If the picture on your Samsung DVD Player is noisy or distorted, check the disc for dirt or scratches. If necessary, clean the disc thoroughly.
Why is my Samsung DVD-F1080 DVD Player showing an abnormal HDMI output screen?
If the HDMI output screen from your Samsung DVD-F1080 shows snow noise, it indicates that your TV does not support HDCP (High-bandwidth Digital Content Protection).
What to do if the screen is blocked on my Samsung DVD-F1080W?
If the screen is blocked on your Samsung DVD Player, press and hold the button on the front panel for more than 5 seconds with no disc inside. This will revert all settings to the factory defaults.
Why does play mode differ from the Setup Menu selection on my Samsung DVD Player?
If the play mode on your Samsung DVD Player differs from the Setup Menu selection, it might be because the disc isn't encoded with the corresponding function.
What to do if I forgot the password for my Samsung DVD-F1080W DVD Player?
If you forgot the password for your Samsung DVD Player, press and hold the button on the front panel for more than 5 seconds with no disc inside. This will revert all settings, including the password, to the factory defaults. Use this method only when absolutely necessary.
General| Type | DVD Player |
|---|---|
| Media Type | DVD, CD |
| Progressive Scan | Yes |
| HDMI Output(s) | 1 |
| Component Video Output(s) | 1 |
| Composite Video Output(s) | 1 |
| Digital Audio Output | Coaxial |
| Dolby Digital Decoding | Yes |
| DTS Decoding | Yes |
| USB Port | Yes |
| Disc Compatibility | DVD-Video, DVD-R, DVD-RW, CD, CD-R, CD-RW |
| Video Output | HDMI, Component, Composite |
To Next Page
