Samsung HW-J470 - Installing the Battery in the Remote Control

10
DESCRIPTIONS
Bluetooth POWER
Press the Bluetooth POWER button on the remote to turn the Bluetooth
POWER On function on and off.
See pages 20 and 22 for details.
WOOFER
You can control the woofer volume.
Press the Woofer button, and then press the # , $ buttons to increase or
decrease the subwoofer volume. You can select SW (-12, -6,-5,-4,-3,-2,
-1,0,+1,+2,+3,+4,+5,+6).
SURR. MODE
Press the SURR. MODE button on the remote to turn SURROUND
SPEAKER on and off. Each time the button is pressed, the selection
changes as follows : ON - SURROUND SPEAKER  OFF - SURROUND
SPEAKER
Volume
Adjusts the volume level of the unit.
Power
Turns the Soundbar on and off.
SURR. LEVEL
Press the SURR. LEVEL button. Then, use the
# , $ buttons to adjust
Surround Speaker volume from -6 to +6.
Play / Pause
Press the
& button to pause a file temporarily.
Press the
& button again to play the selected file.
Skip Back
If there is more than one file on the device you are playing, and you
press the
# button, the previous file is selected.
INSTALLING THE BATTERY IN THE REMOTE CONTROL
1. Use a suitable coin to turn the
remote control's battery cover
counterclockwise to remove it
as shown in the figure above.
2. Insert a 3V lithium battery. Keep the
positive (+) pole facing up when
inserting the battery. Put the battery
cover on and align the '●' marks side
by side as shown in the figure above.
3. Use a suitable coin to
turn the remote control
battery cover clockwise
as far as it will go to fix
it in place.