Samsung HW-J470 - Connections; Subwoofer and Receiver Module Connection

14
CONNECTIONS
Ɣ Do not connect the power cord of this product or your TV to a wall outlet until all connections
between components are complete.
Ɣ Before moving or installing this product, be sure to turn off the power and disconnect the power
cord.
CONNECTING THE SUBWOOFER AND SWA-
7000S TO THE MAIN UNIT
CONNECTING THE SUBWOOFER AND SWA-7000S AUTOMATICALLY
The linking IDs of the SWA-7000S wireless module and the subwoofer are preset at the factory. The
subwoofer and the SWA-7000S should link (connect wirelessly) to the main unit automatically when you turn
on the main unit, the subwoofer, and the SWA-7000s.
1 When the subwoofer and SWA-7000S are completely connected, the blue LED Link indicators on the
subwoofer and the SWA-7000S stop blinking.
CONNECTING SUBWOOFER AND SWA-7000S MANUALLY
If the blue LED lights do not stop blinking when the main unit, subwoofer, and SWA-7000S are turned on,
please reset the linking ID by following the procedure below.
1. Plug the power cords of the main unit, subwoofer, and SWA-7000S into an AC wall outlet.
2. Press the ID SET button on the back of the subwoofer and the SWA-7000S with a small, pointed object for
5 seconds.
1The STANDBY indicator turns off and the LINK indicator (Blue LED) blinks quickly.
3. While the main unit is powered off (in STANDBY mode), press and hold the
(Mute) on the remote
control for 5 seconds.
4. The ID SET message appears on the Soundbar's display.
5. To finalize the link, turn the main unit’s power on while the blue LEDs on the subwoofer and the
SWA-7000S are blinking.
1The main unit, subwoofer, and SWA-7000S should now be linked (connected).
1The Link indicators (Blue LEDs) on the subwoofer and SWA-7000S should be glowing continuously. They
should not be blinking.
1If the Link Indicators are not solid blue, the linking process has failed. Turn off the main unit and start
again from Step 2.
CONNECTIONSCONNECTIONS
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
ID SET
L R