Samsung LE26A41B - Switching on and off; Placing Your Television in Standby Mode

English-11
Switching On and Off
Your set can be placed in standby mode in order to reduce the power
consumption. The standby mode can be useful when you wish to
interrupt viewing temporarily (during a meal, for example).
1 Press the POWER button on the remote control.
Result
: The screen is turned off and a red standby indicator
appears on the front of your set.
2 To switch your set back on, simply press the POWER , numeric
buttons (
0~9) or channel up/down ( / ) button again.
Do not leave your set in standby mode for long periods of time (when you are
away on holiday, for example).
It is best to unplug the set from the mains and aerial.
The mains lead is attached to the rear of your set.
If you have purchased this set in the United Kingdom,
refer to page 59 for further instructions on plug wiring.
1 Plug the mains lead into an appropriate socket.
Result
: The main voltage is indicated on the rear of your set and
the frequency is 50 or 60Hz.
2 Press the POWER button on the lower-right part of the panel.
Result
: The standby indicator lights up on the front panel.
3 Press the numeric button (0~9) or channel up/down ( / ) button
on the remote control or
C/P. button on the lower-right
part of the panel.
Result
: The programme that you were watching last is reselected
automatically.
When you switch the set on for the very first time, you will be
asked to choose language in which the menus are to be
displayed (see page 14).
4 To switch your set off, press the POWER button again.
Placing Your Television in Standby Mode
BN68-00751D-00Eng 7/26/04 7:43 PM Page 13