Switching between Anynet+ Devices
1. Open the Tools menu using your remote, and then select Anynet+ (HDMI-CEC).
2. Select Device List. The Device List screen appears.
✎
If you cannot find a device you want, select Refresh to refresh the list.
3. Select a device, and then wait until the switch to the selected device is completed.
✎
The Device List menu appears only when you set Anynet+ (HDMI-CEC) to On in the System menu.
✎
Switching to the selected device may take up to 2 minutes. You cannot cancel the switching operation
while switching is in progress.
✎
If you have selected an Anynet+ device using the Source function , you cannot use the Anynet+ function.
Make sure to switch to an Anynet+ device using the Device List function.
Listening through a Receiver
You can listen to sound through a receiver (i.e. Home Theatre) instead of the product Speaker. To listen to sound through
a receiver, go to Receiver screen (System → Anynet+ (HDMI-CEC) → Receiver). Then select Receiver and set to On.
✎
If your receiver supports audio only, it may not appear in the device list.
✎
The receiver will work when you have properly connected the optical in jack of the receiver to the DIGITAL AUDIO
OUT (OPTICAL) port of the product.
✎
When the receiver (i.e. Home Theatre) is set to on, you can hear sound output from the product’s Optical jack.
When the product is displaying a DTV (air) signal, the product will send out 5.1 channel sound to the receiver.
When the source is a digital component such as a DVD player and it is connected to the product via HDMI, you
will hear only 2 channel sounds from the receiver.
Using the ARC function
You can listen to sound from the product through a receiver connected using an HDMI cable without connecting a
separate optical cable. To listen to sound through a receiver using the ARC function, go to Receiver screen (System →
Anynet+ (HDMI-CEC) → Receiver). Then select Receiver and set to On.
✎
To use the ARC function, a receiver which supports the HDMI-CEC and ARC features must be connected to the
HDMI IN 2 (MHL / ARC) port.
✎
To disable the ARC function, set the Receiver to Off. Even if the product transmits the ARC signal continuously,
the receiver will be blocked from receiving the signal.
English - 162
To Next Page
Loading...
