Configuring the Basic Settings in Initial Setup
When you turn the product on for the first time, a sequence of screens and on-screen prompts will assist you in
configuring the product’s basic settings. Plug the power cord into a wall outlet, and then press the P button to turn on
the product.
✎
Setup is available only when the Source is set to TV. See "Changing the Input Source" (page 30).
✎
To return to the previous step in the Setup sequence, select Previous.
✎
If you are not using a cable box or satellite box, make sure you have connected the product to an aerial or cable
connection before you turn on the product. See page 20 for instructions.
✎
If you want to configure a wired network connection during Setup, make sure you've connected a LAN cable to
your product. See page 68 for instructions. If you want to configure a wireless network connection during Setup,
make sure your wireless modem or router is on and working. See page 67 for instructions.
1
Use Mode: Select the
Home Use Mode.
On the Use Mode screen, select the Home Use mode using your remote, and then
select Next. The Network Settings screen appears.
✎
Store Demo mode is for retail environments only. If you select Store Demo,
some functions will not work, and the product will reset all functions to their
factory default after a certain period of time. For more information about
Store Demo, go to the end of this section.
2
Network Settings:
Configure the network
settings
✎
To configure
later, select Skip.
You can set up
the network
connection later
using the on-
screen Network
menu.
To configuring your network settings, select Next using your remote, and then go
to 3A - Wireless Network or 3B - Wired Network on the next page.
If you do not know your network configuration information or want to configure
the settings later, or do not have a network, select Skip, and then go to 6 - Auto
Tuning (1) on page 52.
To configure network settings later, refer to the Network Connection sections in
this manual (pages 70 and 73).
Getting Started
To Next Page
Loading...
