Changing the Picture Size
Screen Adjustment
Menu → Picture → Screen Adjustment
Using this function, you can make change to various picture size and aspect ratio options.
• Picture Size
Your cable box / satellite receiver may have its own set of screen sizes as well. However, we highly recommend you
use 16:9 mode most of the time.
Auto Wide (New Zealand, Singaporeonly): Automatically adjusts the picture size to the 16:9 aspect ratios.
16:9: Adjusts the picture size to 16:9 for DVDs or wide broadcasting.
Wide Zoom: Magnifies the picture size more than 4:3.
Zoom: Magnifies the 16:9 wide pictures vertically to fit the screen size.
4:3: The default setting for a movie or normal broadcasting.
✎
Do not watch in 4:3 format for a long time. Traces of borders displayed on the left, right and centre of the
screen may cause image retention (screen burn) which is not covered by the warranty.
Screen Fit: Displays the full image without any cut-off when HDMI (720p / 1080i / 1080p), DTV (1080i, 1080p) or
Component (1080i / 1080p) signals are inputted.
✎
The picture size can vary when you play content from Videos in AllShare Play.
• Zoom/position
Adjusts the picture zoom and position. Zoom is only available if Picture Size is set to Zoom. Position is only available
if Picture Size is set to Wide Zoom, Zoom, or Screen Fit.
To use the Zoom function after selecting Zoom, follow these steps:
1. Select Zoom.
2. On the Zoom/position screen, select Zoom, and then zoom in or zoom out using your remote.
3. When done, select Zoom again, and then select Close.
4. To reset the picture, press Reset.
To use the Position function after selecting Wide Zoom, Zoom or Screen Fit, follow these steps:
1. Select the Position.
2. On the Position screen, select Position, and then move the picture to position you want using your remote.
3. When done, select Position again, and then select Close.
4. To reset the picture position, select Reset.
To Next Page
Loading...
