Other Information
The cabb/set top box remote control • Program the Cable/Sat remote control to operate the TV. Refer to the Cabb/Sat user manual
does not turn the TV on or off, or adjust for SAMSUNG TV code.
the volume.
A "Mode Not Supported" message • Check the supported resolution of the TV and adjust the external device's output resolution
appears, accordingly. Refer to resolution settings in this manual.
Caption on TV menu is greyed out. • Caption can not be selected in the TV menu when connected via HDMI or Component.
• Caption must be activated on the external devbe.
There is a plastic smell from the T_ • This smell is normal and will dissipate over time.
TV Signal Information is unavailable in • This function is only available with digital channels from an Antenna / RF/Coax connection.
the Self Diagnosis Test menu. (R 22)
TV is tilted to the right or left side. • Remove the stand base from the TV and reassemble.
Channel menu is grey out (unavailable). • Channel menu is only available when the TV source is selected (Antenna or Cable).
Your settings are lost after 30 minutes • IfTV is in the Store Demo mode, it will reset audio and picture settings every 30 minutes.
or every time the TV is turned off. Please change from Store Demo mode to Home Use mode in the Plug & Play procedure.
Press the SOURCE button to select TV mode, go to MENU _ Setup _ Plug & Play
ENTER _.
You have intermittent loss of audio or • Check the cable connections and reconnect them.
video. • Loss of audio or video can be caused by using overly rigid or thick cables. Make sure the
cables are flexible enough for long term use. mounting the TV to the wall, we recommend using
cables with 90 degree connectors.
The PIP menu is not available. ,, PIP functionality is only available when you are using a HDMI, PC or components source,
You see small particles when you look ,, This is part of the product's design and is not a defect.
closely at the edge of the frame of the
T_
POP (TV's internal banner ad) appears • Select Home Use under Plug & Play mode.
on the screen. For details, refer to Plug & Play (Initial Setup). (R 7)
This TFT LCD panel uses a panel consisting of sub pixels which require sophisticated technology to produce, However,
there may be a few bright or dark pixels on the screen. These pixels will have no impact on the performance of the
product.
Storage and Maintenance
8 English
To Next Page
Loading...
