GB
25
The timer enables you to switch the system on or off at spe-
cific times.
Example:
You wish to wake up to music every morning.
If you no longer want the system to be switched on or off auto-
matically, you must cancel the timer.
Before setting the timer, check that the current time is correct.
For each step, you have a few seconds to set the required
options. If you exceed this time, you must start again.
Switch the system on by pressing On/Standby.
Press Timer/Clock until TIMER is displayed.
Press Enter on the front panel.
Result:
ON TIME is displayed (instead of the equalizer symbols) for
a few seconds, followed by any switch-on time already set;
you can set the timer switch-on time.
Set the timer switch-on time.
a Set the hour by tuning the Multi Jog knob to the right or to the left.
b Press Enter on the front panel.
Result:
The minutes flash.
c Set the minutes by tuning the Multi Jog knob to the right or to
the left.
d Press Enter on the front panel.
Result:
OFF TIME is displayed (instead of the equalizer symbols)
for a few seconds, followed by any switch-off time already
set; you can now set the timer switch-off time.
Set the timer switch-off time.
a Set the hour by tuning the Multi Jog knob to the right or to the left.
b Press Enter on the front panel.
Result:
The minutes flash.
c Set the minutes by tuning the Multi Jog knob to the right or to
the left.
d Press Enter on the front panel.
Result:
VOL XX is displayed, where XX corresponds to the
volume already set.
Press Tuning Down and Up to adjust the volume level and press
Enter on the front panel.
Result:
The source to be selected is displayed.
Turn the Multi Jog knob to select the source to be played when the
system switches on.
If you select... You must also...
TAPE (cassette) Insert a recorded cassette in one of the
decks before setting the system to standby.
TUNER (radio) a Press
Enter on the front panel.
b Select a preset station by tuning the
Multi Jog knob to the right or to the left.
CD (compact disc) Load one or more compact discs.
Press Enter on the front panel to confirm the timer.
Press On/Standby to set the system to standby mode.
Result
: is displayed to the bottom left of the time, indicating that
the timer has been set. The system will switch on and off
automatically at the required times.
If the timer switch on and off times are identical, the word ERROR is
displayed.
Timer Function
To set the timer function
You may use Multi Jog or
/ buttons to adjust in
step 4,5,6,7.
1
2
3
4
5
6
7
8
9
After having set the timer, it will start automatically as shown
by the TIMER indication on the display. If you no longer wish
to use the timer, you must cancel it.
You can stop the timer at any time (system on or in standby mode).
To... Press Timer On...
Cancel the timer Once.
Result
: is no longer displayed.
Restart the timer Twice.
Result
: is displayed again.
Cancelling the Timer
1,9
6
2
6
4,5,7
3,4,5,6,7,8
MAX-DS750 GB-25~34 9/19/04 10:58 Page 25
To Next Page
Loading...
