MISCELLANEOUS
65
Recording a Radio Program
You can record a radio program of your choice.
You do not need to adjust the volume, as it has no effect on the recording.
2
1 3
Insert a blank
cassette in
TAPE 2.
Switch the system
on by pressing
STANDBY/ON.
•
REC is displayed in red and
recording starts.
54
Select the
TUNER function
by pressing
TUNER/BAND.
Press(
REC/PAUSE
)
button.
6
To stop recording,
press button.
Select the radio
station that you wish
to record by pressing
/DOWN or UP/
button .
66
Timer Function
•
The timer enables you to switch the system on or off at specific times.
•
If you no longer want the system to be switched on or off automatically, you must cancel the timer.
•
Before setting the timer, check that the current time is correct.
•
For each step, you have a few seconds to set the required options.
If you exceed this time, you must start again.
Example: You wish to wake up to music every morning.
•
is displayed to the top right of
the time, indicating that the timer
has been set.
•
The system will switch on and off
automatically at the required
times.
8
9
Press ENTER to
confirm the timer.
•
ON TIME is displayed (instead
of the equalizer symbols) for a
few seconds, followed by any
switch-on time already set; you
can set the timer switch-on time.
•
The source to be selected is
displayed.
2
1
3
Switch the system
on by pressing
STANDBY/ON.
Press TIMER/ CLOCK
until TIMER is
displayed.
Press the ENTER
button.
7
Press or button
to select the source to
be played when the
system switches on.
54
a. Set the hour by pressing or
button.
b. Press ENTER .
•
The minutes flash.
c. Set the minutes by pressing or
button.
d. Press ENTER.
•
OFF TIME is displayed (instead
of the equalizer symbols) for a few
seconds, followed by any switch-
off time already set; you can now
set the timer switch-off time.
•
TAPE (cassette) : Insert a cassette
tape.
•
TUNER (radio) : a Press ENTER.
b Select a preset
station by pressing
or .
•
DVD-OK : Load a compact disc.
a. Set the hour by pressing or
button.
b. Press ENTER.
•
The minutes flash.
c. Set the minutes by pressing or
button.
d. Press ENTER.
•
VOL 10 is displayed, where 10
corresponds to the volume
already set.
Set the timer
switch-off time.
6
Press or
button to adjust the
volume level and
press ENTER.
Set the timer
switch-on time.
Note
•
If the timer switch on and off times are identical, the word ERROR is displayed.
•
You can also use , button on the remote control to instead Multi Jog or button
in step 4,5,6,7.
Press STANDBY/ON
to set the system to
standby mode.
To Next Page
