GB
14
You can store up to:
15 FM stations
8 AM(MW) stations
7 LW stations
Switch the system on by pressing On/Standby.
Select the TUNER function by pressing TUNER on the front panel.
Select the required frequency band by pressing TUNER (Band)
again on the front panel or TUNER (BAND) on the remote control.
Result
: The appropriate indication is displayed:
FM Frequency Modulation
AM(MW) Medium Wave
LW Long Wave
To search for a Press Preset/Manual on the front panel
station... or Tuning Mode on the remote control
Manually
One or more times until MANUAL is displayed.
Automatically One or more times until AUTO is displayed.
Select the station to be stored by:
Turning the Moving Jog knob to the right or to the lef to increase
or decrease the frequency respectively
or
Pressing TUNING or on the remote control
To scroll through the frequencies faster when searching manu-
ally, hold down the Preset/Manual Down or Up buttons.
The automatic search procedure may stop on a frequency that
does not correspond to a radio station. If this happens, use the
manual search mode.
Adjust the volume by:
Turning the Volume knob on the front panel
or
Pressing the VOL. + or – buttons on the remote control
Select the stereo or mono mode by pressing Mono/ST.
If you do not want to store the radio station found, revert to Step 4
and search for another station.
Otherwise:
a Press Preset Memory on the front panel.
Result:
The programme number and PRGM are displayed for a
few seconds.
b Press Preset/Manual Down and Up to assign a programme
number between 1 and 15.
c Press Preset Memory to store the radio station.
Result:
PRGM is no longer displayed and the station is stored.
To store any other radio frequencies required, repeat Steps 3 to 8.
The PROGRAM function can be used to assign a new station to
an existing programme number.
You can listen to a stored radio station as follows:
Switch the system on by pressing On/Standby.
Select the TUNER function by pressing TUNER on remote control.
Select the required frequency band by pressing Tuner (Band) on the
remote control or TUNER (Band) again on the front panel.
Press the Preset/Manual button on the front panel of the unit, or the
Tuning Mode button on the remote control until “PRESET” is displayed.
Tuning the multi-jog on the front panel left or right until the desired
station is found.
or
Select the desired station by pressing the station number stored,
using the Tuning or button on the remote control.
Result:
The desired station is now received.
You can improve the quality of radio reception by:
Rotating the FM or AM(MW) aerial
Testing the positions of the FM and AM(MW) aerials before fixing
them permanently
If reception from a specific FM radio station is poor, press Mono/ST.
to switch from stereo mode to mono. The quality of the sound will be
improved.
Selecting a Stored Station
Improving Radio Reception
Searching for and Storing the Radio
Stations (continued)
1
2
3
4
5
To Next Page
Loading...
