Heating Your Room (Except Cooling Only Models)
You must select the HEAT mode if you wish to adjust the :
Heating temperature
Fan speed when heating
1
If necessary, press
(ON/OFF) button.
Result:
The On/Off indicator on the function controller
comes on.
The air conditioner runs in the mode selected
when the unit was last used.
Caution
The air conditioner is fitted with a protection
mechanism to prevent the unit from being damaged
when it is started immediately after being:
Plugged in
Stopped
lt will start up normally after three minutes.
2
To select the HEAT mode, press the Mode button until
is
displayed at the top of the function controller.
Result:
The air conditioner runs in HEAT mode.
Note
You can change modes at any time.
You can select the HEAT mode only in heat pump models.
To Next Page
Loading...
