Need help?Do you have a question about the Samsung 136S and is the answer not in the manual?
General| Brand | Samsung |
|---|---|
| Model | 136S |
| Category | Controller |
| Language | English |
Provides information for the safe and successful installation of the product.
Intended for system administrators and operators who install and configure the product.
Outlines the document structure, product description, and installation steps.
Details document revisions, including version, description, author, and date.
Lists and defines acronyms and abbreviations used throughout the manual.
Lists the main components of the product for installation reference.
Details Battery Module Type A and Type B, including polarity and model numbers.
Describes the SMU's function, components, and model variants for customers.
Explains SMPS Assembly types with and without System BMS, detailing AC input options.
Describes the rack frame's purpose for mounting components and providing ground connections.
Provides safety warnings and details on grounding methods and wiring compliance.
Presents arc flash related calculations based on system parameters and standards.
Outlines the four main stages of installation: Preparation, Anchoring, Rack, and System.
Details steps for the preparation stage, including planning, unpacking, and inspection.
Lists required parts for unpacking and checks to be performed during the process.
Specifies requirements for ground wires, fasteners, and rack anchoring components.
Lists recommended tools and instruments required for battery installation.
Guides visual inspection of rack frames, modules, SMU, and SMPS assemblies.
Details the process of anchoring rack frames, including safety precautions and clearance distances.
Covers the critical steps for installing components within the rack frame.
Provides instructions for safely removing the front door of the rack.
Details the procedure for inserting and attaching SMU and SMPS assemblies into the rack.
Guides the installation of battery modules, emphasizing order and checking voltage/impedance.
Explains how to assemble fuse-busbar components before installing them into battery modules.
Covers connecting power busbars between modules and to the SMU, with safety notes.
Details the process of connecting signal cables between SMU and battery modules.
Instructs on connecting DC power cables from SMPS Assembly to the SMU.
Explains signal cable connections for SMPS Assembly Type A to SMU.
Guides the connection of AC input power to the SMPS Assembly.
Details connecting ground cables and DC link high-voltage terminals.
Covers powering SMPS Assembly AC inputs to turn on the BMS after installation.
Provides steps for configuring Rack BMS and System BMS using BATTMON software.
Guides the installation and initial setup of the BATTMON software.
Details setting Rack BMS CAN ID, module count, and configuration using BATTMON.
Explains how to connect and configure the System BMS using BATTMON software.
Covers checking communication status by verifying IP settings and running MODBUS.
Guides on setting the PC's IP address for communication with the System BMS.
Details how to check System BMS data and monitor rack/cell information.
Provides steps for reinstalling the front door to secure the rack.
Guides on reinstalling the front panel, securing it with screws and hooks.
Instructs on the final step of switching on the MCCB to connect the battery system.
To Next Page
