■ MH026FPEA / MH035FPEA
The indoor unit is powered from the outdoor unit via the assembly cable.
1.
Remove the screw on the electrical component box and remove the cover plate.
2. Route the connection cord through the side of the indoor unit and connect the cable to terminals; refer to the figure below.
3. Route the other end of the cable to the outdoor unit through the ceiling & the hole on the wall.
4. Reassemble the electrical component box cover, carefully tightening the screw.
■
Wiring Diagram
Operation Instruction & Installation
Samsung Electronics30
Indoor Unit
Outdoor Unit
CommunicationPower
DB98_20402A(1)_1 10/26/04 2:48 PM Page 30
To Next Page
Loading...
