Samsung MIM-D01AN - Page 107

E-107
Enable/Disable Control Logic
1
Click [Control logic management] £ [Setting control logic]
when DMS2.5 web page menu screen appears.
2
Select control logic when control logic screen appears.
3
Click [Apply]/[Not apply].
X The selected control logic will be applied by clicking
[Apply].
X The selected control logic will not be applied by clicking
[Not apply].
Note X When the selected device is Hydro unit, Hydro unit HT or
Single EHS and Thermostat #1 or Thermostat #2 is ON,
the control logic of the desired temperature, water out
temperature and operation mode cannot be controlled.
X When the selected device is Single EHS and the
hot water thermostat is ON, the control logic of
the desired temperature for hot water cannot be
controlled.
1
2
3