E-13
X
Time segmentation is used to divide 24 hours into different sections and to distribute
power according to each section.
X
This function is used when the power consumption fee is different according to
different time slots or when a building is charged differently depending on the
consumption time.
X
1 section (A) is set as 24hours, and the factory default setting is set as 1 section.
The time, 24hours, can also be divided into 2 sections (A,B,A), 3 sections (A,B,C,A) or
4 sections (A,B,C,D,A)
X
DMS2.5 shows the result of the power distribution for each section you set.
Input manually (When setting 2 sections, 3 sections, and 4 sections)
Time Segmentation
If communication error occurs between DMS and the lower level controllers,
actual power consumption and the result of power distribution value may not be
same. Make sure to solve communication error status.
- Example of communication error :
Communication error between DMS2.5 and
SIM(PIM)/SIM(PIM) and watt hour meter/
DMS2.5 and outdoor unit/indoor and outdoor
units.
To Next Page
Loading...
