E-163
1. Check main menus by pressing [Menu], [▲], [▼] or [Set] button.
192.168.0.100
06:12:13(AM)
MAIN MENU
1.IP Config
2. Select 1.IP Config by pressing [▲] and [▼] buttons, and press [Set] button.
X
Network setting screen will be displayed.
3. Select auto address setting function(DHCP CONFIG) by pressing [▼] button.
X
Auto address setting function status will be displayed.
- Current disabled: Auto address setting function disabled
- Current enabled: Auto address setting function enabled
4. Enable/Disable auto address setting function by pressing [Set] button.
X
If auto address setting function enabled
- You can change it to disabled status by pressing [Set] button.
X
If auto address setting function disabled
- You can change it to enabled status by pressing [Set] button.
X
To maintain current status, press [Menu] button.
X
DHCP function is not available when you use BACnet Gateway function.
DHCP CONFIG
Current disabled
Enable DHCP?
YES:Set, NO:Menu
Auto Address Setting (DHCP CONFIG)
To Next Page
Loading...
