E-173
Safety Halt
Safety Halt
1. Check main menus by pressing [Menu], [▲], [▼] or [Set] button.
192.168.0.100
06:12:13(AM)
MAIN MENU
10.Safety Halt
Are you sure?
YES:Set, NO:Menu
Now sleeping..
See you again
3. Press [Set] button.
X
Confirm message will appear.
2. Select 10.Safety Halt by pressing [▲] and [▼] buttons.
4.
P
ress [Set] button.
X
All functions of DMS2.5 will stop and 'Now Sleeping..' phrase will appear.
Note
XSafety halt function is an operation that saves data of DMS2.5 and then
stops service safely. Use this function when relocation and system restart
are needed.
XThis function will not transfer DMS2.5 power to OFF status. Therefore,
when the screen above appears, press [RESET] button on the bottom of
DMS2.5 or remove power cable. If you do not press [RESET] button or
remove power after 1 minutes passed, DMS2.5 will restart automatically.
To Next Page
Loading...
