E-25
10
Select MDS setting .
X You can set MDS(Motion Detection Sensor) through button activation / non
activation.
11
Set cooling/heating discharge temperature by clicking [S] and [T].
X When the indoor unit is in Cool mode, you can adjust cooling discharge temperature
and when the indoor unit is in Heat mode, you can adjust the heating discharge
temperature.
X
When the indoor unit is in Auto, Dry or Fan mode, you cannot adjust the discharged
temperature.
X
Cooling discharged temperature can be set in the range of 8°C(46°F)~18°C(64°F).
X Heating discharged temperature can be set in the range of 30°C(68°F)~43°C(109°F).
12
Select [Control Discharge Temp].
X You can enable/disable button to decide whether to use discharge temperature
adjustment.
Note
When filter warning sign is displayed on indoor unit status window
Select the indoor unit and click [Reset filter].
Filter warning will be released.
X Make sure that each indoor unit must be turned on to control.
X Selecting remote controller, reset filter, operation mode limits, setting lower/upper
temperature limit are possible even if the power of indoor unit is off.
X Some air flow direction option may be restricted depending on the indoor unit
model.
X SPI, MDS and discharge temperature functions can be operated normally when
corresponding optional functions are installed to the selected indoor unit.
To Next Page
Loading...
