E-30
Control and Monitoring (Continued)
Monitoring AHU Operation Status
You can monitor the operation status of AHU, and control AHU as a whole,
or as individual units.
1
Click [Control and Monitoring] when DMS2.5 web page menu screen appears.
X [Control and Monitoring] screen will appear when you log-in to DMS2.5 web page.
2
Check current status of AHU.
X Check AHU status through status display window.
X When the selected AHU is switched on, the remote controller panel will be
automatically activated.
Note
X To control AHU, refer to the ‘Controlling an indoor unit’ steps.
(Refer to the page 20~23)
X AHU’s fan speed is fixed as high.
X You cannot set air flow direction of AHU.
X To set the operation mode limit of AHU, refer to the ‘Indoor unit operation mode
limit’ steps. (Refer to the page 24~25)
X
T
o set the lower/upper temperature limit of AHU, refer to the ‘Setting lower/upper
temperature limit of indoor unit’ steps. (Refer to the page 26~27)
X To set the cooling/heating discharge temperature, refer to the step 11~12 of
'Controlling and indoor unit'. (Refer to the page 23)
X Cooling discharged temperature can be set in the range of 8 °C(46 °F)~25 °C(77 °F).
X Heating discharged temperature can be set in the range of 18 °C(64 °F)~43 °C(109 °F).
1
2
Status display window
To Next Page
Loading...
