E-60
4
Set the control mode.
X
Control mode is used for DMS2.5 to set either 'cool only' or 'heat only' mode to
indoor and outdoor units.
Note
X Mixed operation can occur even if you set limit mode.
X If the indoor unit with operation mode limit is in mixed operation, DMS2.5 will
solve the problem automatically by controlling it in control mode.
X Since Hydro unit HT does not support Cool mode, control mode for Hydro unit HT
can only be set as 'Heat only' or 'None'.
Control and Monitoring (Continued)
X
When you set the operation mode limit, and if the outdoor unit is HP (Heat
pump) type, DMS2.5 will automatically change the operation mode limit setting
of all the indoor units connected to same outdoor unit.
X
If the indoor unit is cooling only model, you cannot set the operation mode limit
to 'heatonly'.
X
DVM CHILLER cannot set 'only' mode.
4
To Next Page
Loading...
