Samsung MIM-H02 - Page 10

9
2) In order to check and set the indoor unit installation option code use the wireless remote controller
High Temp Button
High Fan Button
Mode change
Low Temp Button
Low Fan Button
Entering mode for
option setting
Option setting mode
1. Remove batteries from the remote controller.
2. Insert batteries and while you press [+ Temperature] and
[- Temperature] button at the same time.
3. Check if you have entered the option setting status.
4. After entering the option setting status, select the option as listed below.
Step 2. The procedure of option setting
After entering the option setting status, select the option as listed below.
Option setting is available from SEG1 to SEG 24
• SEG1,SEG7,SEG13,SEG19arenotsetaspageoption.
• SettheSEG2~SEG6,SEG8~SEG12asONstatusandSEG14~18,SEG20~24asOFFstatus.
SEG1 SEG2 SEG3 SEG4 SEG5 SEG6 SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
0 X X X X X 1 X X X X X
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18 SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
2 X X X X X 3 X X X X X
On(SEG1~12) O(SEG13~24)
CAC WiFi Kit APP_03384A(1).indd 9 2012-10-12 오후 3:37:12