Samsung MIM-H02 - Installation Options Configuration

7
5. Setting an indoor unit installation option
f Wi-Fi kit is an optional item, therefore Wi-Fi kit usage option(SEG5) is set to 'Disable' as factory default setting.If you install
the Wi-Fi kit separately, you must set the Wi-Fi kit usage option(SEG5) as shown in the below table to use it normally.
f Input the setting option more than twice.
f For proper operation, reset the power after inputting the option.
❋ Be aware of the fact that Wi-Fi kit will not operate properly if you only install the Wi-Fi kit but don't set the model option.
1) Set the indoor unit installation option by wired remote controller.
Main Menu
Sub-menu
1 2 3 54 6
Data bit
1 2 3 4 5 6
Option CodePage number
SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
0
    
Page number
SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
1
    
Page number
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18
2
    
Page number
SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
3
    
Page number
In order to check and set the indoor unit installation option code use the wired remote controller and follow the directions
below.
1. Press the and buttons at the same time for more than 3 seconds and then a Main menu will be displayed.
2. Press the / button to select and then press button to enter a Sub-menu setting screen.
3. Press the / button to select and then press button to enter a Indoor unit installation option code setting
screen.
• The first digit represents the page number and the remaining five digits are installation option.
• The total option codes are 24 digits. You can set six digits at a time and it is distinguished by page number (0, 1,
2, 3).
NOTE
4. Press the / button to set the installation option code in order. Press button to go to the next page.
CAC WiFi Kit APP_03384A(1).indd 7 2012-10-12 오후 3:37:11