Wireless network setup
28
2. Using a network-connected machine
From the computer
From the computer, we recommend using a USB cable with the
program provided in the supplied software CD.
See "Setup using Windows" on page 34.
• With a USB cable: You can simply set up a wireless network
using the program on the supplied software CD. Only Windows
and Macintosh operating systems are supported (see "Setup
using Windows" on page 34 or "Setup using Macintosh" on page
42).
You can also install a wireless network in Printer Settings
Utility with a USB cable after installing the driver (Windows
and Macintosh operating systems are supported).
• With a network cable: You can set up a wireless network using
the SyncThru™ Web Service program (see "Using a network
cable" on page 48).
15
Using the WPS button
If your machine and an access point (or wireless router) support Wi-
Fi Protected Setup™ (WPS), you can easily configure the wireless
network settings by pressing the (WPS) button on the control
panel without a computer.
If you want to use the wireless network using the
infrastructure mode, make sure that the network cable is
disconnected from the machine. Using the WPS (PBC)
button or entering the PIN from the computer to connect to
the access point (or wireless router) varies depending on the
access point (or wireless router) you are using. Refer to the
user's guide of the access point (or wireless router) you are
using.
Items to prepare
• Check if the access point (or wireless router) supports Wi-Fi
Protected Setup™ (WPS).
• Check if your machine supports Wi-Fi Protected Setup™ (WPS).
• Networked computer (PIN mode only)
To Next Page
Loading...
Need help?
General