Wireless network setup
30
2. Using a network-connected machine
Ź Connecting in PIN mode
1
Press and hold the (WPS) button on the control panel for
more than 2 seconds.
2
The eight-digit PIN appears on the display.
You need to enter the eight-digit PIN within two minutes to
the computer which is connected to the access point (or
wireless router).
The messages are displayed on the display screen in the order
below:
a Connecting: The machine is connecting to the wireless
network.
b Connected: When the machine is successfully connected
to the wireless network, the WPS LED light stays on.
c AP SSID: After completing the wireless network
connection process, the AP’s SSID information is diplayed
on the LCD display.
Machines without an display screen
Ź Connecting in PBC mode
1
Press and hold the (WPS) button on the control panel for
about 2 - 4 seconds until the status LED blinks quickly.
The machine starts connecting to the wireless network. The
LED blinks slowly for up to two minutes until you press the PBC
button on the access point (or wireless router).
2
Press the WPS (PBC) button on the access point (or wireless
router).
a The light blinks fast on the WPS LED. The machine is
connecting to the access point (or wireless router).
b When the machine is successfully connected to the
wireless network, the WPS LED light stays on.
To Next Page
Loading...
Need help?
General