Service Manual
Adjustment and Troubleshooting
4-28
Samsung Electronics
5) Light Image
Description: The printed image is light, with no ghost.
2. Ambient temperature is below than 10°C.
3. Bad contact caused by the toner
stains between the high voltage terminal in
the HVPS and the one in the set.
4. Abnormal output from the HVPS.
(Run self-test and check 1~4)
1. Develop roller is stained when
the toner of toner cartridge is almost
consumed.
Check if the Toner Save mode is off.
Check if the density is light.
No 1 : Replace the toner cartridge
and try to print out.
No 2 : Wait 30 minutes after printer
is powered on before you
start printing.
1. No3 : Clean up the contaminated
area by the toner.
2. Replace the HVPS if the
problems are not solved by the
above four instructions.
To Next Page
Loading...
