ENG
11
Programming the Order of CD Playback
(This function is not available during playback of an MP3/WMA-CD.)
You can decide:
The order of the track desired to listen
◆
The track not desired to listen
◆
You can program up to 24 tracks.
◆
You must stop the compact disc player before selecting the tracks.
◆
If the CD function is selected, stop the player by pressing the
1
STOP (@)
button.
Press the
2
ENTER ( ) button.
Result: The following indications are displayed:
(01 = Program no., -- -- = Track no. on the disc)
Select the required track by pressing the
3
, button:
Press the
◆
button to move back through the tracks.
Press the
◆
button to move forward through the tracks.
Press
4
the ENTER ( ) button to confirm your selection.
Result: The selection is stored and
is displayed.
To select other tracks, repeat Steps
5
3 to 4.
Press
6
PLAY ( ) to listen to the track selection in the order
programmed.
When press
7
the STOP (@) button one time , compact disc player is
stopped, and press the STOP (@) button again to cancel the selection.
If you open the compartment or turn off the power or change
➣
function, the selection is cancelled.
You can check or change your selection of tracks at any time.
Press
1
the STOP (@) button once if you have started listening to the
selection.
Press
2
the ENTER ( ) button.
Result: The following indications are displayed:
(CH = Check, 01=Program No, -- -- = Track No on the disc)
If you have already programmed 24 tracks,
➣
CH is displayed
instead of PROG when you press the ENTER (
) button.
Press
3
the ENTER ( ) button
once or more times until the track to be
changed is displayed.
Press
4
or button to select a different track.
Press
5
the ENTER ( ) button to confirm your change.
Press
6
the PLAY ( ) button to start listening to the selection.
Result: The first track selected is played.
Checking or Changing Programmed
CD Tracks
To Next Page
Loading...
