144
2
Click Run Enrollment Wizard to start the
registration.
3
For the integrated password authentication step,
complete the following.
Enter the Windows user ID and logon password and
click the Next button.
If you do not enter a logon password, the integrated
password authentication function will be permitted
to anyone; it is therefore recommended entering a
logon password.
Creating a user logon password
Select Start > Control Panel > User Accounts >
Create password for user account.
Enter a password in the New Password eld, and
re-enter the password in the Conrm New Password
eld. Click Create Password. A password has been
created.
4
The ngerprint registration begins.
Select the nger to be registered and click the Next
button.
5
Register the ngerprint by placing your nger over
the ngerprint identication sensor and placing it
down slowly.
Repeat this at least 3 times until the next screen
appears automatically.
6
Place the registered nger over the ngerprint
identication sensor again and click the Next button.
7
A window appears asking if you want to register an
additional ngerprint.
Click No to proceed to the next window.
If you click Yes, Steps 5~7 are repeated.
8
Proceed with the settings and click the Next button.
9
When the user prole backup instruction window
appears, read the contents and click on Backup
Now.
Specify a path to save the user prole to and save
the name.
When the backup le password window appears,
enter a password and click the OK button.
What is a user prole backup?
This is a function for backing up the OmniPass
information (ngerprint and user account information)
registered on a computer so that the information can be
used on another computer. For information on how to
use a backed up user prole on another computer, refer
to the Help section.
To Next Page
Loading...
