Samsung NP-X360 - Page 146

145
10
Click Done.
Registering information for using the ngerprint
identication and integrated password
authentication functions has been completed.
Turning the Computer On
This function is applied to some models only.
To use the Turn the computer on function, you have to
register your ngerprint rst and congure it as follows.
When nishing the settings, you can turn the computer on
through ngerprint identication or integrated password
authentication instead of entering a password.
1
Select Start > All Programs > OmniPass >
OmniPass Control Center.
2
Select Change System Settings and then select
either Enable or disable pre-boot authentication
or Do Not Use Authentication before Boot.
3
Select Enable System Boot Authentication and
click the Next button.
4
Enter the Boot Password Setting and click the
Next button.
5
Click Finish to complete the Turn the computer on
function settings.