Samsung NP-X360 - Page 147

146
When turning the computer on, the following screen
appears. Place your nger over the ngerprint
identication sensor and then remove it.
To use a booting password instead of ngerprint
identication, press the <ESC> key to display the
booting password input screen. Enter the booting
password in the screen. Then you can boot up your
computer.
 You can attempt the ngerprint identication up
to three times. If all the three attempts fail, the
computer will automatically shutdown. In this case,
turn the computer on again and retry the ngerprint
identication or enter the booting password.

Canceling the Settings
Unselect the System Boot Authentication
Available option in Step 3 above, and then congure
it according to the instructions that appear on the
screen.
Logging onto Windows
1
If you turn the computer on after completing the
user information registration step, the Logon
Authentication window appears.
 To use the ngerprint identication function
In the Logon User Authentication window, select
AuthenTec Fingerprint Device, place your nger over
the ngerprint identication sensor and place it down
slowly.
If your ngerprint is not recognized, the ngerprint is
displayed in red in the ngerprint display window.
In this case, place your nger over the ngerprint
identication sensor again and push it down slowly until
the ngerprint is displayed in green.