Why do surface burners light but oven burners do not light on my Samsung NX58 560?
If the surface burners light but the oven burners do not, check if the oven door lock is turned on. The display will show the Lock icon. Hold the oven door open and press the START/SET pad for 3 seconds. The oven will beep and the Lock icon will turn off.
What to do if I smell gas from my Samsung NX58 560 Ranges?
If you smell gas, it could indicate a gas leak or that a surface burner knob is not completely in the ‘off’ position while the burner is not ignited. Immediately evacuate everyone from the area. Then, use a neighbor’s phone to call your gas supplier. Follow their instructions carefully. If you cannot reach the gas supplier, contact the fire department.
What does it mean if my Samsung NX58 560 oven control beeps and displays an error code?
If the oven control beeps and shows an error code, it indicates a function error. To resolve this, press the OFF/CLEAR pad and restart the oven. If the issue continues, disconnect the power to the range for at least 30 seconds, then reconnect it. If the problem persists after these steps, it is recommended to call for service.
Why is my Samsung NX58 560 oven light not turning on?
If the oven light isn't working, first check if the oven door lock is turned on. If it is, hold the oven door open and press the START/SET pad for 3 seconds until the Lock icon turns off. Also, check if the Sabbath function has been activated; if so, press and hold the SABBATH pad for 3 seconds to deactivate it. If neither of these is the issue, check for a loose or burned-out bulb.
What to do if the display goes blank on my Samsung NX58 560 Ranges?
If the display goes blank, it could indicate that the electrical outlet Ground Fault Interrupter (GFI or GFCI) has tripped and needs resetting. It could also mean your digital control has been damaged. Replace the fuse or reset the circuit breaker.
Why is my Samsung Ranges warming drawer not working (Model NX58*565***)?
If the warming drawer isn't working, first ensure the controls are properly set. The warming drawer will not operate during Self-Clean or Sabbath functions; try again after these are completed or canceled. Also, check if the oven controls have been locked and unlock them if necessary. Finally, check for a blown fuse or tripped circuit breaker and replace or reset as needed.
Why are my Samsung Ranges burners not burning evenly?
If your burners aren't burning evenly, it could be due to incorrectly assembled or unlevel surface burner components and caps. Also, dirty surface burners can cause uneven flames. Clean the surface burner components thoroughly.
Why is there excessive smoking during a self-cleaning cycle on my Samsung NX58 560 Ranges?
If there's excessive smoking during the self-cleaning cycle, especially the first time, it's typically normal. Wipe up any excessive soiling before starting. If the smoke persists, press the OFF/CLEAR pad and ventilate the room. Once cooled and unlocked, wipe up any remaining soil and reset for self-cleaning.
Why are my Samsung NX58 560 surface burners not lighting?
If the surface burners on your range aren't lighting, first make sure the control knob is correctly set by pushing it in and turning it to the LITE position. Also, check that the burner caps are properly placed and the burner base is correctly aligned. Cleaning the electrodes may also help.
Why won't all the burners light on my Samsung NX58 560 Ranges?
If all burners fail to light, several factors could be responsible. First, ensure the power cord is properly plugged into a functioning, grounded electrical outlet. Next, check your home's fuse box or circuit breaker and replace any blown fuses or reset tripped breakers. Finally, verify that the gas supply is correctly connected and turned on, referring to the Installation Instructions for guidance.
General| Type | Freestanding |
|---|---|
| Fuel Type | Gas |
| Number of Burners | 5 |
| Self-Cleaning | Yes |
| Convection Oven | Yes |
| Color | Stainless Steel |
Highlights new features, capacity, and cooktop configuration.
Identifies appliance parts and components with diagrams.
Covers general hazards, symbols, and basic precautions.
Specific safety procedures for gas detection and usage.
Covers electrical requirements, grounding, and installation safety.
How to use cooktop burners, griddle, and cookware.
Explains oven controls, baking, roasting, broiling, and special modes.
Instructions for using the warming drawer for food.
Guides on cleaning oven, cooktop, and exterior surfaces.
Provides solutions for common range problems and error codes.
Details the limited warranty for products sold in the US.
Details the limited warranty for products sold in Canada.
To Next Page