CHAPTER 1. Ошибка! Используйте вкладку "Главная" для применения 제목 1,장 제목 1 к тексту, который должен
здесь отображаться.
1-6
© SAMSUNG Electronics Co., Ltd.
1.3 Programming
The Man Machine Communication (MMC) program can change the data value used for the
system operation program. The MMC program is categorized into three levels, which are
technician, operator, and subscriber. Depending on these levels, some MMCs can be
programmed by the subscribers while some MMCs cannot.
A password is required for technician level programming or operator level programming;
however, a password is not required for subscriber level programming.
Technician-Level Programming
All programs are programmable. Programming can be made in any stations in OfficeServ
system, but the programming can be made only in a station at the same time.
Operator Level Program
The operator can program only the program specified in ‘Specification of Program 802
Operator Program Range’ by a technician. Programming can be made in any stations in the
tenant group, but the programming can be only made in a station at the same time.
Subscriber Level Program
Only subscriber programs are programmable.
To Next Page
Loading...
