Samsung OfficeServ 7100 Series - Rings and Tones; Ring Cycles; Tones; Table 3.9 System Ring Cycles

CHAPTER 3. Ошибка! Используйте вкладку "Главная" для применения 제목 1,장 제목 1 к тексту, который должен
здесь отображаться.
3-8
© SAMSUNG Electronics Co., Ltd.
3.4 Rings and Tones
3.4.1 Ring Cycles
OfficeServ 7100 provides the trunk line rings, station rings, door rings, and alarm rings.
The ON/OFF cycle of each ring is shown in the table below:
Table 3.9 System Ring Cycles
Rings
ON/OFF Cycles
Trunk line ring
1000/3000 ms
Station ring
400/200/400/3000 ms
Door ring
400/200/400/200/400/2000 ms
Alarm ring
400/200/400/200/400/200/400/1000 ms
Ring ON/OFF Cycle
The ON/OFF cycle can be adjusted by changing the values of the system
database
3.4.2 Tones
The output voltage and the frequency of the ring signals in OfficeServ 7100 are as follows:
 Output voltage: 75 V
 Frequency: 20 Hz
OfficeServ 7100 provides the users with various tones to notify the users of the status of
functional operation and give feedback to the users.
The ON/OFF cycles of currently specified tones are shown in the table below:
Table 3.10 Cycles of the System Tones
Tones
ON/OFF Cycles
Dial tone
1000/250 ms
Busy Tone
500/500 ms
Do Not Disturb tone
250/250 ms
Ring Back tone
1000/2000 ms
Call Park tone
Continuous
Confirmation/Caution/Barge-In tone
50/50 ms
Call Back/Hold tone
500/3500 ms
Ring Back tone
1000/2000 ms
Error/Number Unobtainable tone
250/250 ms
Message Camp On tone
Continuous