Samsung PM32F

71
Chapter 5. Menu
Problem Possible Solution
The message
“Disconnecting
Anynet+ device ...”
appears on the screen.
• You cannot use the remote control when you are
conguringAnynet+orswitchingtoaviewmode.
• Use the remote control after the product has
completedAnynet+congurationorhasnished
switching to Anynet+.
The Anynet+ device
does not play.
• You cannot use the play function when initial setup is in
progress.
The connected device
is not displayed.
• Check whether or not the device supports Anynet+
functions.
• Check whether or not the HDMI cable is properly
connected.
• Check whether Anynet+ (HDMI-CEC) is set to On in the
System menu.
• Search Anynet+ devices again.
• Anynet+requiresanHDMIconnection.Makesure
the device is connected to your product with an HDMI
cable.
• Some HDMI cables may not support Anynet+ functions.
• If the connection is terminated because there has
been a power failure or the HDMI cable has been
disconnected, please repeat the device scan.