Samsung ProXpress M458x Series - Page 316

Installing driver over the network
317
3. Network Setup
7
Linux
You need to download Linux software packages from the Samsung website to
install the printer software (http://www.samsung.com > find your product >
Support or Downloads).
1
Make sure that the machine is connected to your network and powered
on. Also, your machine’s IP address should have been set.
2
Copy Unified Linux Driver package to your system.
3
Open Terminal program and go to the folder that you copied
thepackage to.
4
Extract the package.
5
Move to uld folder.
6
Execute ” ./install.sh“ command (If you are not logged in as root,execute
the command with “sudo” as “sudo ./install.sh”).
7
Proceed with installation.
8
When installation finished, launch Printing utility (Go to System >
Administration > Printing or execute “system-config-printer“
command in Terminal program).
9
Click Add button.
10
Select AppSocket/HP JetDirect and enter your machine’s IP address.
11
Click Forward button and add it to your system.
8
UNIX
• Make sure your machine supports the UNIX operating system before
installing the UNIX printer driver (see "Operating System" on page 8).
• The commands are marked with “”, when typing the commands, do not
type “”.
• Some features and optional goods may not be available depending on
model or country (see "Operating System" on page 8).
To use the UNIX printer driver, you have to install the UNIX printer driver
package first, then setup the printer. You can download the UNIX printer driver
package from the Samsung website (http://www.samsung.com > find your
product > Support or Downloads).
Installing the UNIX printer driver package
The installation procedure is common for all variants of UNIX OS mentioned.