English - 43
1. Press the D.MENU button to display the DTV menu.
2. Press the ▲ or ▼ button to select "Setup", then press the
ENTER/OK button.
3. Press the ▲ or ▼ button to select "System", then press the
ENTER/OK button.
4. Press the ▲ or ▼ button to select "Software Upgrade",
then press the ENTER/OK button.
5.
Press the
▲ or ▼
button to select "Software Infomation",
"Manual Upgrade" or "Standby Mode upgrade".
Press the ENTER/OK button.
Software information
Press the ENTER/OK button, then the current software
version is shown.
Manual Upgrade
Press the ENTER/OK button to search for new software
from the currently broadcasting channels. The operations are
same as you enter the software information.
Standby Mode Upgrade : On / Off
Press the ENTER/OK button. To continue software
upgrade with master power on, Select On by pressing
the ▲ or ▼ button.
45 minutes after entering standby mode, a manual
upgrade is automatically conducted. Since the power
of the unit is turned on internally, the screen may be
on slightly for the PDP product. This phenomenon may
continue for more than 1 hour until the software upgrade
is completed.
6. To switch to an alternative version, press the red button.
Press the blue button to reset, activate the upgrade and
restart.
7. Press the EXIT button to exit.
Software Upgrade
Software Information
Manual Upgrade
Standby Mode upgrade : On
Move Enter Return
Software Upgrade
Software Information
Manual Upgrade
Standby Mode upgrade : On
Move Enter Return
Software Upgrade
Move Return Info
Current Software: T_BDX2DAUO_1001
Default
Alternative Software: T_BDX2DAUO_1100
(New version)
Switch Default Software
Software Upgrade
Move Return Info
Current Software: T_BDX2DAUO_1001
Default
Alternative Software: T_BDX2DAUO_1100
(New version)
Switch Default Software
Software Upgrade
Move Return Info
Current Software: T_BDX2DAUO_1001
Default
Alternative Software: T_BDX2DAUO_1100
(New version) New Default
Confirm
Manual Upgrade
Move Return Info
New software is being downloaded.
10%
Stop
To Next Page
Loading...
