English - 58
Scanning and Switching between Anynet+ Devices
Air28
Move Enter
Return
View TV
Select Device
Record
Menu on Device
Device Operation
Receiver :Off
Setup
DVDR1
DVDR2
DVD1
DVD2
Setup
Anynet+ (HDMI-CEC) : Off
Auto Turn Off : Off
Searching Connections
Enter Return Return
1. Press the Anynet+ button.
2. Press the ▲ or ▼ button to select Select Device, then
press the ENTER/OK button.
3. Press the ▲ or ▼ button to select to a particular device
and press the ENTER/OK button.
It is switched to the selected device.
4. If you cannot find a device you want, press the ▲ or ▼
button to select Searching Connections, then press the
ENTER/OK button.
The meassage Configuring Anynet+ connection... is
displayed. When searching devices completes, the
connected devices are listed in the Anynet+ menu.
Switching to the selected devices may take up to 2 minutes.
You cannot cancel the operation during the switching operation.
The time required to scan for devices is determined by the
number of connected devices.
When the device scan is complete, the number of found
devices is not displayed.
Although the TV automatically scans devices when it is turned
on using the POWER button, devices connected when the TV is on or under a specific circumstance
are not displayed in the device list. Therefore select Searching Connections menu to search
devices.
If you have selected external input mode by pressing the SOURCE button, you cannot use the
Anynet+ function. Make sure to switch to an Anynet+ device by using the Anynet+ button.
Anynet+ Menu
The Anynet+ menu changes depending on the type and status of the Anynet+ devices connected
to the TV.
Anynet+ Menu Description
View TV Switches from Anynet+ to TV broadcast mode.
Select Device Your TV connects to the corresponding device.
Record Starts a recording. (This menu works only for a device
supporting recording.)
Menu on Device Shows the menu of the connected device.
Example. When a DVD Recorder is connected, the DVD
Recorder’s title menu appears.
Device Operation Shows the play control menu of the connected device.
Example. When a DVD Recorder is connected, the play
control menu of the DVD Recorder appears.
Receiver Sound is output through the receiver.
Setup You can set the environment for using Anynet+.
To Next Page
Loading...
