English - 59
TV Remote Control Buttons Available in Anynet+ Mode
Device Type Operating Status Available Buttons
Anynet+ Device
After switching to the
device, when the menu of
the corresponding device is
displayed on the screen.
Numeric buttons
▲/▼/◄/►/ENTER buttons
Color buttons
EXIT button
After switching to the device,
while playing a file
◄◄ (Backward search)
►►(Forward search)
(Stop)
►II (Play/Pause)
Device with built-in Tuner After switching to the device,
when you are watching a TV program
CH ▲/▼ button
Audio Device
When Receiver is activated
VOL +/- button
MUTE button
Anyview2 When watching TV ►II (Play/Pause)
The Anynet+ function only works when the remote control is set to TV.
The REC button works only while in the recordable state.
You cannot control Anynet+ devices using the buttons on the side of the TV. You can control Anynet+
devices only using the TV remote control.
The TV remote control may not work under certain conditions. In this case, re-select the Anynet+
device.
The Anynet+ functions don’t operate for the products from other manufacturers.
In Anynet+ mode, the color buttons may not work properly.
The ◄◄, ►► operations may differ depending on the device.
You can make a recording of a TV program using a recorder.
Press the REC button.
Recording begins. (Only when the Anynet+ enabled recording device is connected.)
The current TV program is recorded in the Watching TV status. If you are watching video from
another device, the video from the device is recorded.
You can also record the source streams by selecting Record after pressing the Anynet+
button.
Before recording, check whether the antenna jack is properly connected to the recording
device. For the antenna connection to the recording device, refer to its user manual.
Recording
To Next Page
Loading...
