The problem Try this!
The message "Connecting
to Anynet+ device..." or
"Disconnecting from Anynet+
device" appears on the screen.
You cannot use the remote control when the TV is conguring Anynet+ or switching
to the TV viewing screen.
Use the remote control after the TV has completed the Anynet+ conguration or has
switched to the TV viewing screen.
The Anynet+ device won't play. You cannot use the play function when Reset is in progress.
The connected device is not
displayed.
Check whether the device supports Anynet+.
Anynet+ devices must be connected to the TV using an HDMI cable. Make sure the
device is connected to your TV with an HDMI cable. Some HDMI cables may not
support Anynet+.
Check whether the HDMI cable is properly connected.
Go to Anynet+ (HDMI-CEC) and see if Anynet+ (HDMI-CEC) has been set to On.
• Settings General External Device Manager Anynet+ (HDMI-CEC)
Scan for Anynet+ devices again.
If the connection is terminated because there has been a power failure or the HDMI
cable has been disconnected, please scan for the device again.
- 187 -
To Next Page
Loading...
Need help?
General
