① If Power Freeze Key + Power Cool Key are pressed simultaneously for 6 seconds,
All ON/OFF will blink at 0.5 second intervals for 2 seconds.
② If taking the finger off from the keys when above blinking condition and press Fridge Key,
load condition mode will be started.
1) If Power Freeze Key + Power Cool Key are pressed simultaneously for 6 seconds, ALL ON/OFF will
blink at 0.5 second intervals for 2 seconds.
2) At this moment, if taking the finger off from Power Freeze Key + Power Cool Key and pressing Fridge
Key, load condition display mode will be returned with alarm ("Ding-dong").
3) Load condition display mode shows the load that MICOM signal is outputting. But, it means that MICOM
signal is outputting and does not means whether load is operating or not actually. That is, though load
operation is displayed, load could not be operated by actual load error, PCB relay error, or etc. And this
function would be applied at Service (A/S).
4) Load condition display function will maintain for 30 seconds and then normal condition will be returned
automatically.
5) Load condition display is as below.
35
4-1-3. Display function of Load condition
TROUBLESHOOTING
To Next Page
Loading...
