Chapter 3. Installing the Product 3-21
▐ Control
Trackball Speed for Scan Mode
Specify the trackball speed at scanning mode as Slow, Normal, or Fast.
Trackball Speed for Measurement
Specify the trackball speed at measurement as Slow, Normal, or Fast.
Slower speeds allow more precise measurements.
▐ Scan Mode
Simultaneous Mode
You can decide whether to enable Simultaneous Mode in Spectral Doppler
Mode, using the following three options:
- Off: Select this if you do not wish to use Simultaneous Mode.
- Allow B/PW: Select this option if you do not wish to use Simultaneous
Mode in 2D/C/PW Modes, but do wish to use it in 2D/PW Mode
- Allow B/C/PW: Select this if you wish to use simultaneous mode for
both 2D/PW and for 2D/C/PW.
Dual Mode
Select whether to activate the Change window in Dual Mode.
Dual Live
Select the position of the Color Doppler Mode in Dual Live Mode.
- Left / Top: Color Doppler Mode is located in the left or upper part of the
screen.
- Right / Bottom: Color Doppler Mode is located in the right or lower part
of the screen.
- Dual Live Left-Right Dual Only: The Top-Bottom Dual button
disappears when you check this checkbox.
Freeze Action
Select a function to execute when the Freeze button on the control panel is
pressed. Available options are BodyMarker, Caliper, Measure, AutoCalc,
and None.
- D or M Mode Only: When the Freeze Action is set to Measure,
Measure Freeze Action will function only in Doppler and M Modes.
To Next Page