28
2nd Description
Auto Source Switch+ By activating, a new connected source is displayed automatically.
―
This function may not be supported depending on the model or
geographical area.
Panel Care Adjusts settings to protect the screen.
Logo Brightness
Prevents screen issues by lowering the brightness of fixed images,
such as logos and banners.
Pixel Refresh
Adjusts pixels to provide a clearer screen.
Key Repeat Time Control the response rate of a button when the button is pressed.
Acceleration, 1 sec, or 2 sec can be selected. If No Repeat is selected,
a command responds only once when a button is pressed.
Power LED On Configure the settings to enable or disable the power LED located at
the lower part of the product.
• Working: The power LED is on when the product is turned on.
• Stand-by: The power LED is on when the product is turned off.
Setup Custom Key Set the custom key so that your chosen function can be set up
directly.
• Eye Saver Mode / PIP / Ultrawide Game View / Black Equalizer /
Virtual Aim Point / Infinity Core Lighting / Auto Source Switch+
/ Picture Mode
VRR Control By optimising the video signal processing, this additional function
mitigates screen flicker.
While playing any game or content that causes screen flicker, use
the VRR Control function with setting it to On.
2nd Description
DisplayPort Ver. Select your Displayport.
―
Incorrect settings may cause the screen to go blank. If this occurs,
check the device specifications.
―
If the product (in DisplayPort mode) is displaying the message Check
the cable connection and the settings of the source device. press the
JOG button to display the Function Key Guide screen and then select
→ System → DisplayPort Ver..
―
If setting the DisplayPort Ver. to 1.1, for the bandwidth limitation of
the DisplayPort 1.1 protocol, the actual maximum output refreshing
rate of the graphics cards cannot achieve the level of 120 Hz / 144 Hz /
165 Hz.
―
If the PC has entered BIOS mode and the BIOS screen does not appear,
go to the following path and then select the mode.
→ System →
DisplayPort Ver..
Input Port Ver. Select an HDMI version. (1.4 / 2.0↑)
―
The supportable device and resolution may differ depending on its
version.
―
When the version is changed, the screen may blink.
―
If you set the HDMI mode to 1.4, some high resolutions may not be
supported because of bandwidth limitation of the HDMI 1.4 protocol.
―
When the setting is not appropriate, a blank screen may appear. In
this case, check the specifications of the device.
―
Set HDMI mode to 1.4 if the monitor is connected to an HDMI device
and the monitor does not display the screen properly, displays a blank
screen, or does not play sound at all.
To Next Page
Loading...
