29
Support
2nd Description
Self Diagnosis Perform this test when you experience a problem with your
monitor's picture.
―
Never turn off the power nor change the input source during self
diagnosis. If possible, try not to interrupt testing.
Software Update Update software using an update file on a USB device.
1
Save the update file (in .bin or .img format) that you downloaded
from the Samsung website (http://www.samsung.com) to a USB
storage device.
2
Connect the USB device to the port on the monitor.
Select → Support → Software Update.
3
Follow the instructions on the screen to proceed with update.
4
Your product will turn itself off and on again automatically after
completing update, and then turn off your product.
5
Remove the power cord from the power outlet and then
reconnect the cord after turning off.
―
To perform software update by using a USB memory, first format the
USB memory to FAT32.
―
When performing update, make sure that only one BIN or IMG file (.bin
or .img) is saved in the root directory.
―
Upon updates, save only either the .bin or .image file, downloaded
from the Samsung website, to the root directory.
―
If the No update files found on your USB device. Please check your
USB device and try again. message is displayed, this is probably due
to the following reasons.
2nd Description
Software Update
―
A USB memory is not connected to the
port.
―
The files in the connected USB memory are not compatible formats.
―
There are no valid update files found in the connected USB memory.
(There are no update files saved in the memory or the file names
are incorrect.)
―
Do not turn off the product until the update is complete. And prevent
the updating from any interruption as far as possible. In general, the
product returns to the previous version if an update is interrupted.
―
It may change the screen colour or blink during USB update, but it
is not a monitor problem. Since S/W update is performed normally,
please wait until the update is finished.
Information View product information like model name.
Reset All Return all the settings for the product to the default factory
settings.
To Next Page
Loading...
