75
Standby Control
You can set the screen standby mode to be applied when an input signal is received.
• Auto
Power-saving mode will activate if no input signals are detected even though a source
device is connected to the display.
The message No Signal will appear if no source device is connected.
• Off
The message No Signal will appear if no input signals are detected.
―
If No Signal is displayed although a source device is connected, check the cable
connection.
―
If No Signal Message is set to Off, the No Signal message does not appear.
If this is the case, set No Signal Message to On.
• On
Power-saving mode will activate if no input signals are detected.
Network Standby
This feature keeps the network power on when the product turns off.
• Off / On
Power Button
The power button can be set to either turn on the power or turn on/off the power.
• Power on only: Set the power button to turn on the power.
• Power on and off: Set the power button to turn on/off the power.
Eco Solution
m MENU → System → Eco Solution → E
No Signal Power Off
Save power by turning the device off when no signal is received from any source.
• Off / 15 min / 30 min / 60 min
―
Disabled when an attached PC is in power saving mode.
―
The product will automatically power off at a specified time. The time can be changed as
required.
Auto Power Off
The product will automatically turn off if you don’t press a button on the remote or touch a
button on product front panel within select hours to prevent overheating.
• Off / 4 hours / 6 hours / 8 hours
Temperature Control
m MENU → System → Temperature Control → E
This function detects the internal temperature of the product. You can specify the temperature
range that is acceptable.
The default temperature is set to 100 °C.
The recommended operating temperature for this product is 95 to 100 °C (based on an ambient
temperature of 40 °C).
―
The screen will become darker if the current temperature exceeds the specified temperature
limit. If the temperature continues to rise, the product will power off to prevent overheating.
To Next Page
Loading...
