Samsung SCD-3083 - Component Names and Functions

ಲ
y
y
COMPONENT NAMES AND FUNCTIONS
English_11
●
INTRODUCTION
RED (MD_OUT
WHITE (EXT_DN)
BLACK (GND)
➑
➏
➐
➌
⓬
❶
4
5
2
⓫
❿
➒
Dome Cover
Shield Case
Pan Base
: control panning angle of camera
Function Setup Switch
Video Output Terminal to Monitor
Rotate Base
: control rotating angle of camera.
Power Input Connector
Ground Terminal
D & N Input Terminal :
You can switch to Day & Night Mode by connecting
an external signal to this terminal.
MD Output Terminal:
Motion detection signals are output through this terminal.
Video Output Jack
Be sure to connect the Day & Night input terminal to GND when using an external input. 
M
❶
2
➌
5
➏
➐
➑
➒
❿
⓫
⓬
4
3 ~ mm (F1.2)
8.5
2.8 Vari-focal Lens Module
for adjusting zoom.
When menu is off,
and right amend or confi rm changes.
: Display the OSD menu and move the cursor up, down, left,
move this switch left(NEAR) or right(FAR)
for adjusting focus. move this switch up(TELE) or down(WIDE)
Short to press this button to fit the focus
automatically.